Hennepin County Radon: Ten Years of Tests and a Winter Peak
Hennepin County radon is unusually well measured. Labs and licensed testers report their results to the Minnesota Department of Health, and its data portal turns nearly 79,000 county tests from 2016 to 2025 into a handful of numbers worth knowing.
MDH data for 2016–2025 put the Hennepin County average at 3.4 pCi/L, with 34% of properties at 4 or more and 71% at 2 or more. Statewide, winter tests average 4.2 pCi/L and summer tests 3.3, because a heated house draws soil gas in through its lowest level.

What do Hennepin County radon tests show?
- Volume: about 7,900 properties tested a year, the most of Minnesota's 87 counties.
- Average: 3.4 pCi/L, against EPA's U.S. indoor average of 1.3.
- At or above 4 pCi/L: 34.0%, roughly one property in three.
- At or above 2 pCi/L: 71.2%.
- Top 5% of results: above 8.1 pCi/L.
These come from homes whose owners chose to test and whose labs reported to MDH, so they are not a random sample. MDH also stresses that houses on the same street can differ widely. What the numbers do show is that a high result in Minneapolis is ordinary, not a fluke.
How does Hennepin compare with neighboring counties?
Average result and share at 4 pCi/L or more, 2016 to 2025 (MDH Radon Data Portal):
- Wright: 4.1 pCi/L, 42.3%
- Scott: 4.1 pCi/L, 40.8%
- Carver: 3.6 pCi/L, 34.9%
- Dakota: 3.5 pCi/L, 33.9%
- Hennepin: 3.4 pCi/L, 34.0%
- Washington: 3.2 pCi/L, 27.9%
- Ramsey: 3.0 pCi/L, 26.8%
- Anoka: 2.3 pCi/L, 15.3%
Anoka, the one county here rated Zone 2 on EPA's 1993 map, also has the lowest average, which fits the map. Yet even there about one test in seven reached 4 pCi/L, a reminder that EPA says its map should not decide whether any single home gets tested.
Why do readings rise when the furnace runs?
MDH describes three forces that pull soil gas indoors. The stack effect: warm air rises and leaks out up high, and make-up air enters low, partly from the soil. Wind: strong gusts over the roof push and pull air through the house. And a vacuum effect: water heaters, fireplaces, dryers, older furnaces and exhaust fans all remove air that must be replaced. A long Minneapolis winter keeps the first force running for months; NOAA's 1991–2020 normals for Minneapolis–St. Paul airport show 7,399 heating degree days a year and a December-to-February average of 19.6°F. MDH's statewide seasonal averages follow suit: 4.2 pCi/L in winter, 4.1 in fall, 3.9 in spring and 3.3 in summer. MDH adds that taller homes have more potential for stack effect.
What should one household take from the county numbers?
That a test is worth doing and a high result would be no surprise, but only your own house's number counts. Test in the heating season, in the lowest regularly used level, and follow MDH's follow-up steps in radon testing in Minneapolis. If the result holds at 4 pCi/L or more, the price picture is in what radon mitigation costs in Minneapolis.
What is going on with radon at your house?
A test number, a vent pipe with no fan, a gauge that reads level, a closing date: any one of these is enough to start. One independent radon mitigation specialist serving Minneapolis reads it and replies.